1. INSTALL CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL CENTER REAR NO. 2 SEAT LAP BELT ASSEMBLY WITH INNER
HINT:
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
3. INSTALL REAR NO. 2 SEAT BELT ASSEMBLY INNER
HINT:
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Terminals of ECU
1. CHECK OUTER MIRROR CONTROL ECU LH
Disconnect the O9 and O10 connectors.
Measure the voltage and resistance according to
the value(s) in the table below.
Voltage
Resistance
If the result is not as specified, there may be a
malfunction on the wire harness side.
Recon ...
Center Airbag Sensor Assembly Malfunction
DTC B1100/31 Center Airbag Sensor Assembly Malfunction
DESCRIPTION
The center airbag sensor assembly consists of the center airbag sensor
assembly, safing sensor, drive
circuit, diagnosis circuit and ignition control, etc.
It receives signals from the airbag sensor, judges whether or not the ...
Room temperature sensor (for rear air conditioning system)
ON-VEHICLE INSPECTION
1. INSPECT REAR A/C ROOM TEMPERATURE SENSOR
(a) Remove the rear A/C room temperature sensor.
(b) Disconnect the connector from the rear A/C room
temperature sensor.
(c) Measure the resistance according to the value(s) in
the table below.
Standard resistance
NOTI ...