1. INSTALL DISTANCE CONTROL ECU ASSEMBLY
Torque: 5 N*m (51 kgf*cm, 44 in.*lbf)
NOTICE: Do not install the dropped or shocked distance control ECU assembly.
2. INITIALIZE DISTANCE CONTROL ECU
NOTICE: After replacing the distance control ECU, it is necessary to initialize the distance control ECU so that the ECU can recognize the specification of the vehicle.
NOTICE: Do not turn the headlight dimmer switch on at this time because the optical axis automatic adjustment mode has already started, which may lead to an incorrect optical axis setting. If the headlight dimmer switch is turned on by mistake, readjust the optical axis
How to proceed with
troubleshooting
HINT:
Use the following procedures to troubleshoot the cruise
control system.
*: Use the intelligent tester.
1 VEHICLE BROUGHT TO WORKSHOP
2 PROBLEM SYMPTOM CONFIRMATION
3 CHECK MULTIPLEX COMMUNICATION SYSTEM*
Refer to HOW TO PROCEED WITH TROUBLESHOOTING.
Check fo ...
Vanity light
ON-VEHICLE INSPECTION
1. LH VISOR ASSEMBLY
Inspect vanity light resistance.
check that the resistance exists between the
terminal 1 and the terminal 2 when the light is
operated.
Resistance:
OFF (closed):
10 kΩ or higher
ON (opened):
Below 1 Ω
2. RH VISOR ...
Side Airbag Sensor Assembly LH Circuit Malfunction
DTC B1141/33 Side Airbag Sensor Assembly LH Circuit Malfunction
DESCRIPTION
The side airbag sensor LH circuit consists of the center airbag sensor
assembly and side airbag sensor
LH.
If the center airbag sensor assembly receives signals from the side airbag
sensor LH, it judges whether or
...