1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
2. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
3. INSTALL COWL TOP VENTILATOR LOUVER SUBASSEMBLY
4. INSTALL FR WIPER ARM LH
Torque: 20 N*m (204 kgf*cm, 14.8 ft.*lbf)
HINT: Hold down the arm hinge by hand to fasten the nut.
5. INSTALL FR WIPER ARM RH
Torque: 20 N*m (205 kgf*cm, 15 ft.*lbf) HINT: Hold down the arm hinge by hand to fasten the nut.
6. INSTALL FRONT WIPER ARM HEAD CAP
Coolant Thermostat (Coolant Temperature
Below Thermostat Regulating Temperature)
DTC P0128 Coolant Thermostat (Coolant Temperature
Below Thermostat Regulating Temperature)
HINT:
This DTC relates to the thermostat.
DESCRIPTION
This DTC is set when the Engine Coolant Temperature (ECT) does not reach 75C
(167F) despite
sufficient engine warm-up time
DTC No.
...
DTC check / clear
1. CHECK DTC
Connect the intelligent tester to the DLC3.
Connect the intelligent tester to the Controller
Area Network Vehicle Interface Module (CAN
VIM). Then connect the CAN VIM to the Data
Link Connector 3 (DLC3).
Turn the ignition switch to the ON posi ...
Fuel Pump Primary Circuit
DESCRIPTION
This DTC is designed to detect a malfunction in the fuel pump (FUEL
PUMP) relay circuit. When the
system is normal, the battery voltage is applied to FPR terminal of the ECM
while the FUEL PUMP
relay is turned OFF. If the battery voltage is not applied to the FPR
ter ...