1. INSTALL COMBINATION METER ASSEMBLY
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
NOTICE: Some systems need initialization when disconnecting the cable from the negative battery terminal.
Installation
1. INSTALL BACK DOOR GLASS
Clean and shape the contact surface of the vehicle
body.
Using a knife, cut away any rough adhesive on
the contact surface of the body to ensure the
appropriate surface shape.
HINT:
Leave as much adhesive on the body as
possible.
& ...
Initialization
1. RESET SLIDING ROOF MOTOR
If the AUTO operation function does not operate,
reset the sliding roof motor using any of the
following methods.
Press the sliding roof switch on the TILT UP side
and hold it until the sliding roof motor stops.
Then release the switch and leave it untou ...
Safety Connect
Safety Connect is a subscription-based telematics service that
uses Global Positioning System (GPS) data and embedded cellular
technology to provide safety and security features to subscribers.
Safety Connect is supported by Toyota’s designated
response center, which operates 24 hours per da ...