Toyota Sienna Service Manual: Installation
1. INSTALL NO.1 NAVIGATION BRACKET
- Install the No.1 navigation bracket with the 4 screws.
2. INSTALL NO.2 NAVIGATION BRACKET
- Install the No.2 navigation bracket with the 4 screws.
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL UPPER
- Install the instrument cluster finish panel upper with the 4 screws.
4. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
- Connect the connector.
- Install the navigation receiver assembly with bracket with the 4 screws.
Removal
1. REMOVE INSTRUMENT CLUSTER NO.1 FINISH PANEL CENTER
2. REMOVE INSTRUMENT CLUSTER NO.2 FINISH
PANEL CENTER
3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
4. REMOVE NAVIGATION RECEIVER ASSEMBLY ...
Navigation antenna
COMPONENTS
...
Other materials:
Installation
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Pull in the control cable to the body.
(b) Install the cable end, as shown in the illustration.
(c) When installing the transmission control cable
assembly on the shift lever plate, place the
projection of the shift cable downward to ...
Inspection
1. INSPECT PRELOAD
(a) Using SST(s) and a torque wrench, check the initial
torque within the backlash range.
SST 09326-20011
Torque: 0.9 to 1.4 N*m (9 to 14 kgf*cm, 8.0 to
12.4 in.*lbf)
HINT:
Use a torque wrench with a fulcrum length of 160
mm (6.30 in.).
(b) Using SST(s) and a torque w ...
Air outlet control servo motor
ON-VEHICLE INSPECTION
1. INSPECT AIR OUTLET CONTROL SERVO MOTOR
(a) Remove the air outlet control servo motor.
(b) Connect the positive (+) lead from the battery to
terminal 4 and negative (-) lead to terminal 5, then
check that the lever turns to "DEF" position.
(c) Connect ...
