Toyota Sienna Service Manual: Installation
1. REMOVE MASS AIR FLOW METER
- Install the mass air flow meter with the 2 screws.
- Connect the mass air flow meter connector.
Inspection
1. INSPECT MASS AIR FLOW METER
Visually check for any foreign matter on the
platinum hot wire (heater) of the mass air flow
meter.
OK:
There is no foreign matter.
If the resu ...
VVT sensor
COMPONENTS
...
Other materials:
Reassembly
1. INSTALL TRANSFER DRIVEN PINION REAR BEARING
(a) Using SST(s) and a press, install the transfer driven
pinion rear bearing outer race to the transfer case.
SST 09950-60010 (09951-00620), 09950-70010
(09951-07150)
NOTICE:
Place something like wood blocks under the
case to keep its level. ...
Disassembly
1. REMOVE BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY
(a) Using soft jaws on the vise, hold the brake master
cylinder in a vise through aluminum plates.
(b) Using a screwdriver, remove the O-ring.
(c) Using SST, remove the brake tube from the brake
master cylinder.
SST 09023 ...
Calibration
1. SELECT COMPASS DISPLAY MODE
The MODE switch allows you to select the Display
or Non-display mode of the compass.
HINT:
In compass display mode, the display indicates
outside temperature/average fuel consumption/
instantaneous fuel consumption/distance to empty
with compass.
2. ...
