Toyota Sienna Service Manual: Installation
1. INSTALL CRANKSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
- Install the crankshaft position sensor with the bolt.
Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
- Connect the crankshaft position sensor connector.
2. INSTALL COMPRESSOR AND MAGNETIC CLUTCH
Inspection
1. INSPECT CRANKSHAFT POSITION SENSOR
Using an ohmmeter, measure the resistance
between the terminals.
Standard resistance
NOTICE:
"Cold" and "Hot" ...
Engine coolant temperature sensor
COMPONENTS
...
Other materials:
Installation with LATCH system (third seat)
Manual seat
Fold the seatback while pulling
the strap. Return the seatback
and secure it at the 1st lock
position (most upright position).
Adjust the seatback to the
11th lock position.
1st lock position
11th lock position
Power seat
Fold down the seatb ...
Back Door ECU Communication Stop
DTC B1287 Back Door ECU Communication Stop
DESCRIPTION
DTC B1287 is output when communication between the power back door ECU and
the multiplex network
gateway ECU stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B1287
Back d ...
Removal
NOTICE:
Do not adjust the brake booster push rod.
Do not change the combination of the diameter
converting unit and brake.
1. REMOVE FRONT WHEEL
2. DRAIN BRAKE FLUID
NOTICE:
Wash the brake fluid off immediately if it attaches to
any painted surfaces.
3. SEPARATE BATTERY NEGATIVE TERM ...
