1. INSTALL KNOCK CONTROL SENSOR
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
2. INSTALL INTAKE MANIFOLD
3. INSTALL FUEL MAIN TUBE SUB-ASSEMBLY
4. INSTALL INTAKE AIR SURGE TANK
NOTICE: DO NOT apply oil to the bolts listed below.
Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
Torque: Nut
16 N*m (163 kgf*cm, 12 ft.*lbf)
Bolt
21 N*m (214 kgf*cm, 15 ft.*lbf)
5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
7. ADD ENGINE COOLANT
8. INSPECT FOR ENGINE COOLANT LEAK
9. INSPECT FOR FUEL LEAK
10. INSTALL FRONT OUTER COWL TOP PANEL SUBASSEMBLY
11. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
12. INSTALL V-BANK COVER SUB-ASSEMBLY
Cooling fan motor
On-vehicle inspection
1. No. 1 Cooling fan motor
(A) check that the motor turns smoothly when the
battery is connected to the fan motor connector.
(B) measure the current while the motor is turning.
Standard current:
11.8 To 14.8 A at 20°c (68°f)
if the result is not as specified, r ...
Definition of terms
Terms
Definitions
Monitor Description
Description of what ECM monitors and how to detect malfunctions
(monitoring purpose and details).
Related DTCs
A group of diagnostic trouble codes that are output by ECM based on
the same malfunction detection lo ...
Precaution
CAUTION:
The vehicle is equipped with a Supplemental Restraint
System (SRS). It consists of a driver airbag, front
passenger airbag, front seat side airbag, curtain shield
airbag, and front seat belt pretensioner. Failure to
carry out service operations in the correct sequence
co ...