1. INSTALL STEERING PAD
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)
2. INSTALL STEERING WHEEL NO.3 COVER LOWER
3. INSTALL STEERING WHEEL NO.2 COVER LOWER
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INSPECT STEERING PAD
HINT: If the horn does not sound, inspect the horn system.
6. PERFORM INITIALIZATION
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
7. INSPECT SRS WARNING LIGHT
Fuel Pump Primary Circuit
DESCRIPTION
This DTC is designed to detect a malfunction in the fuel pump (FUEL
PUMP) relay circuit. When the
system is normal, the battery voltage is applied to FPR terminal of the ECM
while the FUEL PUMP
relay is turned OFF. If the battery voltage is not applied to the FPR
ter ...
Problem symptoms table
HINT:
Proceed to the troubleshooting for each circuit in the table
below.
Occupant Classification System
Symptom
Suspected area
The front passenger seat condition differs from the
indication by the passenger airbag ON/OFF indicator
(DTC is not output).
Trouble ...
Data list / active test
HINT:
By accessing the DATA LIST displayed on the intelligent
tester, you can perform such functions as reading the values
of switches and sensors without removing any parts. Reading
the DATA LIST as the first step in troubleshooting is one
method to shorten labor time.
1. DATA LIST FOR CENTER ...