1. INSTALL SPIRAL CABLE
NOTICE: If it is not in the neutral position, the pin of the turn signal switch may snap.
NOTICE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL STEERING COLUMN COVER
3. ADJUST SPIRAL CABLE
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
NOTICE: Do not turn the spiral cable by the airbag wire harness.
NOTICE: Do not turn the spiral cable by the airbag wire harness.
HINT: The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.
4. INSTALL STEERING WHEEL ASSEMBLY
5. INSPECT STEERING WHEEL CENTER POINT
6. INSTALL STEERING PAD
7. INSTALL STEERING WHEEL NO.2 COVER LOWER
8. INSTALL STEERING WHEEL NO.3 COVER LOWER
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INSPECT STEERING PAD
11. PERFORM INITIALIZATION
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
12. INSPECT SRS WARNING LIGHT
Indicators
The indicators inform the driver of the operating state of the vehicle’s
various systems.
*1: If equipped
*2: These lights turn on when the engine switch is turned to the “ON” position
(vehicles without a smart key system) or IGNITION ON mode (vehicles
with a smart key system) to ...
Front Occupant Classification Sensor LH Collision
Detection
DTC B1785 Front Occupant Classification Sensor LH Collision
Detection
DESCRIPTION
DTC B1785 is output when the occupant classification ECU receives a collision
detection signal sent by
the front occupant classification sensor LH if an accident occurs.
DTC B1785 is also output when the front ...
Problem symptoms table
SLIDING ROOF SYSTEM
Symptom
Suspected area
AUTO function does not operate
Sliding roof motor assembly
Sliding roof system does not operate
ECU-IG fuse
S/ Roof fuse
IG1 relay
Sliding roof housing assembly
Sliding roof motor switc ...