Toyota Sienna Service Manual: Installation
1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
- Install the front passenger airbag assembly with the 2 screws.
2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
3. CONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR
- Connect the connector to the front passenger airbag assembly.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
4. INSTALL INSTRUMENT PANEL BOX NO.2
5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
6. INSTALL STEERING COLUMN COVER
7. INSTALL STEERING WHEEL ASSEMBLY
8. INSPECT STEERING WHEEL CENTER POINT
9. INSTALL STEERING PAD
10. INSTALL STEERING WHEEL NO.2 COVER LOWER
11. INSTALL STEERING WHEEL NO.3 COVER LOWER
12. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14. PERFORM INITIALIZATION
- Perform initialization.
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
15. INSPECT SRS WARNING LIGHT
- Inspect the SRS warning light
Removal
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting th ...
Disposal
HINT:
When scrapping a vehicle equipped with the SRS or
disposing of the front passenger airbag assembly, be sure to
deploy the airbag first in accordance with the procedure
described below. If an ...
Other materials:
2Gr-fe engine mechanical
SERVICE DATA
TORQUE SPECIFICATIONS
2GR-FE FUEL
SERVICE DATA
TORQUE SPECIFICATIONS
2GR-FE EMISSION CONTROL
SERVICE DATA
TORQUE SPECIFICATIONS
2GR-FE INTAKE
SERVICE DATA
TORQUE SPECIFICATIONS
2GR-FE EXHAUST
SERVICE DATA
TORQUE SPECIFICAT ...
Power back door main switch
INSPECTION
1. INSPECT POWER BACK DOOR MAIN SWITCH
Inspect the resistance of the main switch.
Resistance
If the result is not as specified, replace the switch.
Apply battery voltage and check the illuminates.
OK
HINT:
Whether the switch illuminates or not will not affect
th ...
Using the voice command system
Press the talk switch.
Select to train voice recognition.
Select to start the voice recognition
tutorial.
Select “OK” and say the desired command.
On the list screen, you can select the desired command.
To cancel the voice command system, press and hold the talk sw ...
