HINT:
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
NOTICE: Do not twist the curtain shield airbag assembly LH when installing it.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL POWER BACK DOOR UNIT ASSEMBLY
3. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (4).
4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
5. INSPECT STEERING WHEEL CENTER POINT
6. INSTALL STEERING PAD
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
9. INSPECT SRS WARNING LIGHT
Wrong Disc/ Disc cannot be Read
DTC 63-41 Wrong Disc
DTC 63-42 Disc cannot be Read
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-41
An unsuitable disc is inserted
CD
Radio and navigation assembly
63-42
The disc cannot be read
INSP ...
On-vehicle inspection
1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY
(VEHICLE NOT INVOLVED IN COLLISION)
Perform a diagnosis system check.
2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY
(VEHICLE INVOLVED IN COLLISION AND AIRBAG
HAS NOT DEPLOYED)
Perform a diagnosis system check.
3. INSPECT CENTER AIRBAG ...
Cranking Holding Function Circuit
DESCRIPTION
The system detects the ignition switch's starting signal (STSW) and then
supplies current to the starter
until the ECM judges that the engine has started successfully. The purpose is to
reduce the holding time
of the ignition key.
WIRING DIAGRAM
Refer to DTC P0617 (See page ...