1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
NOTICE:
Torque: 17.5 N*m (179 kgf*cm, 13 ft.*lbf)
2. INSTALL AIR DUCT NO.1 REAR
3. INSTALL AIR DUCT NO.3 REAR
4. INSTALL AIR DUCT NO.4 REAR
5. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER
6. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER
7. INSTALL INSTRUMENT PANEL BOX NO.2
8. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
9. INSTALL FLOOR CARPET COVER CENTER LH
10. INSTALL FLOOR CARPET COVER CENTER RH
HINT: Use the same procedures for the floor carpet cover center RH and floor carpet cover center LH.
11. INSTALL INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER LH
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
13. PERFORM INITIALIZATION
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
14. INSPECT SRS WARNING LIGHT
Removal
1. REMOVE FRONT DOOR WINDOW FRAME MOULDING
Remove the screw.
Using a heat light, heat the front door window frame
moulding between 40 to 60 C (104 to 140 F).
NOTICE:
Do not heat the front door window frame
moulding excessively.
Slide the front door window frame moulding upward
...
Installation
1. INSTALL VANE PUMP ASSEMBLY
(a) Temporarily install the bolt to the vane pump
assembly.
(b) Install the vane pump assembly.
(c) Temporarily install the bolt (B).
(d) Using SST, tighten the 2 bolts.
SST 09249-63010
Torque:Without SST
43 N*m (439 kgf*cm, 32 ft.*lbf)
With SST
29 ...
Installation
1. INSTALL HEATED OXYGEN SENSOR (for Bank 2
Sensor 2)
(a) Using SST, install the heated oxygen sensor to the
front exhaust pipe.
SST 09224-00010
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use
with SST
44 N*m (449 kgf*cm, 32 ft.*lbf) for use
without SST
HINT:
Use a torque wrench wit ...