1. INSTALL OCCUPANT CLASSIFICATION ECU
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
NOTICE:
2. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
3. INSTALL FRONT RH SEAT ASSEMBLY (for Power Seat)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
6. INSPECT SLIDE ADJUSTER LOCK (for Manual Seat)
7. INSPECT POWER SEAT OPERATION (for Power Seat)
8. INSPECT SEAT HEATER OPERATION (w/ Seat Heater System)
9. INSPECT SRS WARNING LIGHT
Removal
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT:
Refer to the instructions for disassembly of the front
seat assembly (for flat type).
Refer to the instructions for disassembly of the front
seat assembly (for manual seat).
Refer to the instructions for disassembly of the ...
Diagnosis system
1. CHECK DLC3
The vehicle uses ISO 15765-4 communication
protocol.
The terminal arrangement of the DLC3 complies
with SAE 1962 and matched the ISO 15765-4
format.
If the result is not as specified, the DLC3 may have
a malfunction. Repair or replace the harness and
connecto ...
Terminals of ecu
Check tire pressure warning ecu
HINT:
Inspect the connectors from the back side while the
connectors are connected.
(a) Disconnect the tire pressure warning antenna and
receiver connector.
(b) Measure the voltage according to the value(s) in the
table below.
(c) Connect the tire pr ...