Toyota Sienna Service Manual: Installation
1. INSTALL SIDE REAR WINDOW WEATHERSTRIP LH
2. INSTALL QUARTER WINDOW LOCK ASSEMBLY LH
3. INSTALL POWER VENT WINDOW MOTOR ASSEMBLY LH
4. INSTALL SIDE WINDOW ASSEMBLY REAR LH
5. INSTALL RR WINDOW SIDE GARNISH ASSEMBLY LH
6. INSTALL RR WINDOW SIDE GARNISH ASSEMBLY NO.2 LH
7. REMOVE QUARTER TRIM PANEL ASSEMBLY LH
8. INSTALL REAR DOOR SCUFF PLATE LH
9. INSTALL ROOF HEADLINING GARNISH REAR
10. INSTALL BACK DOOR SCUFF PLATE
11. INSTALL ROPE HOOK ASSEMBLY
12. INSTALL REAR DOOR WEATHERSTRIP LH
13. INSTALL REAR NO. 1 SEAT ASSEMBLY LH
HINT:
- Captain seat type
- Center seat type
Removal
HINT:
On the RH side, use the same procedures as on the LH side.
1. REMOVE REAR NO. 1 SEAT ASSEMBLY LH
HINT:
Captain seat type:
Center seat type:
2. REMOVE REAR DOOR WEATHERS ...
Back door glass
COMPONENTS
...
Other materials:
VC Output Circuit
DESCRIPTION
The ECM constantly uses 5 V from the battery voltages supplied to the +B (BATT)
terminal to operate the
microprocessor. The ECM also provides this power to the sensors through the VC
output circuit.
When the VC circuit is short-circuited, the microprocessor in the ECM and
sens ...
Clock setting
Display the “General Settings” screen.
Operations up to this point can also be performed by select the clock
display
at the top of most screens.
Select the items to be set.
Manual clock setting
Set minutes to 00
The 24-hour time format can
be to on/off.
Select ...
If the battery is
discharged
The following procedures may be used to start the engine if the
vehicle’s battery is discharged.
You can call your Toyota dealer or qualified repair shop.
If you have a set of jumper (or booster) cables and a second vehicle
with a 12-volt battery, you can jump start your vehicle by following ...
