1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for captain seat type).
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
3. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY
HINT:
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
4. INSTALL REAR SEAT INNER BELT ASSEMBLY
HINT:
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Installation
1. INSTALL BACK DOOR GLASS
Clean and shape the contact surface of the vehicle
body.
Using a knife, cut away any rough adhesive on
the contact surface of the body to ensure the
appropriate surface shape.
HINT:
Leave as much adhesive on the body as
possible.
& ...
Terminals of ECU
1. CHECK POWER SLIDE DOOR ECU LH
Disconnect the P25 and P26 ECU connectors, and
check the voltage and resistance of each terminal of
the wire harness side connectors
If the result is not as specified, there may be a
malfunction on the wire harness side.
Reconnect the EC ...
Removal
1. PRECAUTION
HINT:
See page RS-1
2. DISCONNECT BATTERY NEGATIVE TERMINAL
Wait for 90 seconds after disconnecting the battery
terminal to prevent the airbag working.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEERING WHEEL COVER LOWER NO.2
(See page RS-424)
5. REMOVE STEERING WH ...