1. INSTALL NO. 2 REAR SEAT OUTER BELT ASSEMBLY
NOTICE: Do not disassemble the retractor.
If operation is not as specified, replace the No.
2 rear seat outer belt assembly.
Torque: Upper bolt
8.5 N*m (87 kgf*cm, 75 in.*lbf)
Lower bolt
42 N*m (430 kgf*cm, 31 ft.*lbf)
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL 3 POINT TYPE REAR SEAT BELT ASSEMBLY (for 8-Passenger)
NOTICE: Do not disassemble the retractor.
If operation is not as specified, replace the 3 point type rear seat belt assembly.
Torque: Upper bolt
8.5 N*m (87 kgf*cm, 75 in.*lbf)
Lower bolt
42 N*m (430 kgf*cm, 31 ft.*lbf)
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
NOTICE: The check should be performed with the assembly installed.
If operation is not as specified, replace the belt 3 point type rear seat belt assembly.
NOTICE: The check should be performed with the assembly installed.
If operation is not as specified, replace the 3 point type rear seat belt assembly.
3. INSTALL NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for captain seat type).
If operation is not as specified, replace the No.
1 rear seat outer belt assembly.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
NOTICE: The check should be performed with the assembly installed.
If operation is not as specified, replace the No.
1 rear seat outer belt assembly assembly.
NOTICE: The check should be performed with the assembly installed.
If operation is not as specified, replace the No.
1 rear seat outer belt assembly.
4. INSTALL REAR WINDOW SIDE GARNISH ASSEMBLY
5. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
NOTICE: Do not make the anchor part run onto the protrusion part of the floor panel.
NOTICE: The check should be performed with the assembly installed.
6. INSTALL BACK DOOR SCUFF PLATE
7. INSTALL BACK DOOR WEATHERSTRIP
8. INSTALL REAR DOOR WEATHERSTRIP
9. INSTALL REAR DOOR SCUFF PLATE
Battery
Check the battery as follows:
Battery exterior
Make sure that the battery terminals are not corroded and that
there are no loose connections, cracks, or loose clamps.
Terminals
Hold-down clamp
Before recharging
When recharging, the battery produces hydrogen gas which is flammable an ...
Installation
1. INSTALL ECM
Install the ECM with the 2 nuts.
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
Connect the 5 ECM connectors.
2. INSTALL ECM (with 10 speakers system)
Install the ECM and stereo components amplifier
with the 4 nuts.
Torque: 5.5 N*m (56 kgf*cm, 49 ...
Programming the HomeLink® (for U.S.A. owners)
The HomeLink® compatible transceiver in your vehicle has 3 buttons
which can be programmed to operate 3 different devices. Refer to the
programming method below appropriate for the device.
Indicator light
Buttons
Programming the HomeLink®
Point the remote control for
the d ...