Toyota Sienna Service Manual: Installation
1. INSTALL CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
- Install the center rear seat lap type belt assembly
with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL CENTER REAR NO. 2 SEAT LAP BELT ASSEMBLY WITH INNER
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Install the center rear No. 2 seat lap belt assembly
with inner with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
3. INSTALL REAR NO. 2 SEAT BELT ASSEMBLY INNER
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Install the rear No. 2 seat belt assembly inner with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Removal
1. REMOVE CENTER REAR SEAT LAP TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for disassembly of the rear No. 1
seat assembly (for center seat).
Remove the bolt and ...
Rear center seat outer belt assembly
COMPONENTS
...
Other materials:
Open in Occupant Classification ECU Battery
Positive Line
DTC B1794 Open in Occupant Classification ECU Battery
Positive Line
DESCRIPTION
This circuit consists of the occupant classification ECU and the power source
circuit (battery, fuse, wire
harness).
DTC B1794 is recorded when a malfunction is detected in the occupant
classification ECU or t ...
Adjustment
HINT:
On the RH side, use the same procedures as on the LH side.
1. INSPECT SLIDE DOOR PANEL SUB-ASSEMBLY LH
Check that the clearance is within the standard
range.
Standard
2. ADJUST SLIDE DOOR PANEL SUB-ASSEMBLY LH
Using the SST, horizontally and vertically adjust the
do ...
Installation
1. INSTALL REAR DOOR GLASS WEATHERSTRIP
Install the rear door glass weatherstrip.
2. INSTALL SLIDE DOOR WINDOW ASSEMBLY
3. INSTALL REAR DOOR GLASS RUN
4. INSTALL REAR DOOR TRIM BOARD SUBASSEMBLY
5. INSTALL SIDE TRIM BOARD COVER REAR
6. INSTALL REAR DOOR WINDOW FRAME SUBASSEMBLY
7. INSTA ...
