Toyota RAV4 manuals

Toyota Sienna Service Manual: Installation

1. INSTALL FRONT SEAT ASSEMBLY LH

INSTALL FRONT SEAT ASSEMBLY LH

  1.  Place the seat assembly in the cabin.

    NOTICE: Be careful not to damage the body.

  2.  Connect the connectors under the seat assembly.
  3.  Tighten the 2 bolts on the front side of the seat assembly.

    Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)

  4.  Tighten the 2 bolts on the rear side of the seat assembly.

    Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)

  5.  Install the 2 seat track covers.

2. INSTALL FRONT SEAT HEADREST ASSEMBLY

3. CHECK SRS WARNING LIGHT

4. CHECK SEAT SLIDE ADJUSTER LOCKS

5. INITIALIZE OCCUPANT CLASSIFICATION SYSTEM

Reassembly
1. INSTALL SEAT POSITION AIRBAG SENSOR (for Driver Seat) 2. INSTALL FRONT SEAT CUSHION SHIELD LOWER LH  Install the front seat cushion shield lower LH with the screw. 3. INSTALL FRONT S ...

Front seat assembly (for Power Seat)
COMPONENTS ...

Other materials:

Seat Position Airbag Sensor Circuit Malfunction
DTC B1153/25 Seat Position Airbag Sensor Circuit Malfunction DESCRIPTION The seat position airbag sensor circuit consists of the center airbag sensor assembly and the seat position airbag sensor. DTC B1153/25 is recorded when a malfunction is detected in the seat position airbag sensor cir ...

Selecting conventional constant speed control mode
Constant speed control mode differs from vehicle-to-vehicle distance control mode. When constant speed control mode is selected, your vehicle will maintain a set speed regardless of whether or not there are other vehicles in the lane ahead. Press the “ON-OFF” button to activate the ...

Open in CAN Main Bus Line
DESCRIPTION There may be an open circuit in the CAN main bus wire and/or the DLC3 branch wire when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is 69 Ω or higher. Symptom Trouble Area Resistance between terminals 6 (CANH) and 14 (CANL) of t ...

© 2011-2024 Copyright www.tsienna.net