Toyota Sienna Service Manual: Installation
1. INSTALL FRONT SEAT ASSEMBLY LH
- Place the seat assembly in the cabin.
NOTICE: Be careful not to damage the body.
- Connect the connectors under the seat assembly.
- Tighten the 2 bolts on the front side of the seat
assembly.
Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)
- Tighten the 2 bolts on the rear side of the seat
assembly.
Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)
- Install the 2 seat track covers.
2. INSTALL FRONT SEAT HEADREST ASSEMBLY
3. CHECK SRS WARNING LIGHT
4. INSPECT POWER SEAT OPERATION
5. CHECK SEAT HEATER OPERATION
6. INITIALIZE OCCUPANT CLASSIFICATION SYSTEM
Reassembly
1. INSTALL SEAT POSITION AIRBAG SENSOR (for Driver Seat)
2. INSTALL LUMBAR SUPPORT ADJUSTER
ASSEMBLY LH
Install the seat side table leg cover.
3. INSTALL FRONT SEAT CUSHION SHIELD LOWER LH
...
Rear no. 1 Seat assembly (for Captain Seat Type)
COMPONENTS
...
Other materials:
Compressor Lock Sensor Circuit
DTC B1422/22 Compressor Lock Sensor Circuit
SYSTEM DESCRIPTION
The ECM sends an engine speed signal to the A/C amplifier via CAN
communication and BEAN
communication.
The A/C amplifier reads the difference between compressor speed and engine
speed. When the
difference becomes too large, t ...
Active head restraints
When the occupant’s lower back
presses against the seatback during
a rear-end collision, the head
restraint moves slightly forward
and upward to help reduce the
risk of whiplash on the seat occupant
Active head restraints
Even small forces applied to the seatback may cause the head rest ...
Route cannot be Calculated
INSPECTION PROCEDURE
1 CHECK MAP DISC
Check that the map disc is not deformed or cracked.
OK:
No deformations or cracks on map disc.
2 SET DESTINATION
Set another destination and check if the system can
calculate the route correctly.
OK:
Route can be correctly calculated.
NO ...
