Toyota Sienna Service Manual: Installation
1. INSTALL REAR NO. 1 SEAT ASSEMBLY CENTER
- Place the seat in the cabin.
NOTICE: Be careful not to damage the body.
- Install the rear seat.
- Install the seat belt anchor plate with the bolt.
Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
- Install the headrest.
- When sliding the seat, check that the both sides of the adjuster lock simultaneously.
HINT: Check that the seat adjuster locks.
Reassembly
1. INSTALL NO. 1 SEAT CUSHION FRAME SUBASSEMBLY
Install the seat cushion frame with the bolt.
Torque: 20.6 N*m (210 kgf*cm, 15 ft.*lbf)
2. INSTALL RECLINING CONTROL LINK SUBASSEMBLY
...
Rear no. 2 Seat assembly (for Manual Seat Type LH
Side)
COMPONENTS
...
Other materials:
Installation
1. Connect inlet sub-assembly
(a) Connect the inlet hose to the radiator.
(b) Install the inlet sub-assembly to the radiator with the
bolt.
Torque: 7.1 N*m (72 kgf*cm, 63 in.*lbf)V
2. Install no. 2 Radiator support
(A) install the no. 2 Radiator support to the radiator with
the 2 ...
Engine compartment
Items
Check points
Battery
Check connections
Brake fluid
Is the brake fluid at the correct level?
Engine coolant
Is the engine coolant at the correct
level?
Engine oil
Is the engine oil at the correct level?
Exhaust system ...
Power back door opener / closer switch
INSPECTION
1. INSPECT SATELLITE SWITCH
Inspect the resistance of the back door switch.
Resistance
If the result is not as specified, replace the switch.
Apply battery voltage and check whether the switch
illuminates.
Standard
HINT:
Whether the switch illuminates or not wi ...
