Toyota Sienna Service Manual: Installation
1. INSTALL REAR NO. 2 SEAT ASSEMBLY RH
- Place the rear No. 2 seat assembly RH in the cabin.
NOTICE: Be careful not to damage the body.
- Install the seat with the bolt.
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
- Install the locus cable RH with the bolt.
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
- Install the rear seat headrest assembly RH.
HINT: Check that the seat leg locks.
2. INSTALL REAR SEAT LEG SIDE GARNISH SUBASSEMBLY RH
- Install the rear seat leg side garnish sub-assembly RH.
Reassembly
1. INSTALL REAR SEAT STAY SUB-ASSEMBLY
Install the seat stay sub-assembly with the nut.
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
2. INSTALL NO. 2 SEAT CUSHION SPRING ASSEMBLY
RH
3. INS ...
Rear no. 2 Seat assembly (for Power Seat Type LH Side)
COMPONENTS
...
Other materials:
Outer mirror switch
Inspection
1. INSPECT OUTER MIRROR SWITCH ASSEMBLY (w/o
Memory)
The L side of the left / right adjustment switch:
Inspect the mirror switch resistance.
Standard resistance (Left side)
If the result is not as specified, replace the switch
assembly.
The R side of t ...
Rear door lock
INSPECTION
1. INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY LH
Apply battery voltage to the door lock and check
operation of the motor.
OK
HINT:
If the result is not as specified, replace the door lock
assembly.
Measure the resistance according to the value(s) in
the ...
Fail-safe chart
If any of the following DTCs are set, the ECM enters fail-safe
mode to allow the vehicle to be driven temporarily.
HINT:
*1: The vehicle can be driven slowly when the accelerator
pedal is depressed firmly and slowly. If the accelerator
pedal is depressed quickly, the vehicle may ...
