1. INSTALL ROOF DRIP SIDE FINISH MOULDING
Heating temperature:
NOTICE: Do not heat the body and moulding excessively.
NOTICE: Install the moulding when 30 minutes or more have passed after press-fitting the clips.
HINT:
Magnetic clutch relay
ON-VEHICLE INSPECTION
1. INSPECT MAGNETIC CLUTCH RELAY
(a) Remove the magnetic clutch relay.
(b) Measure the resistance according to the value(s) in
the table below.
Standard resistance
If the resistance is not as specified, replace the
magnetic clutch relay. ...
Radio and Navigation Assembly Communication Error
INSPECTION PROCEDURE
1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor"
mode.
Identify the component shown by the sub-code.
HINT:
"110 (multi-display)" i ...
Diagnosis Circuit
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking the SRS warning light.
HINT:
When each warning light stays blinking, a ground short in the
wiring of terminal TC of the DLC3 or an
internal ground short in each ECU is ...