Toyota Sienna Service Manual: Installation
1. INSTALL FRONT DOOR WINDOW FRAME MOULDING
- Remove the tape from the front door window frame moulding.
- Clean the contact surface of the vehicle body with white gasoline.
- Clean the outer circumference of the front door window frame moulding with white gasoline.
- Apply new double-sided tape to the front door window frame moulding, as shown in the illustration.
Dimensions:
- Using a heat light, heat the vehicle body and front door window frame moulding.
Heating temperature:
NOTICE: Do not heat the body and front door window frame moulding excessively.
- Remove the peeling paper from the face of the front
door window frame moulding face.
HINT: Be careful that dirt or foreign objects do not stick to the adhesive part when removing the peeling paper.
- Engage the 2 claws and install the front door window frame moulding with the screw.
NOTICE: Do not apply excessive force onto the front door window frame moulding, but steady pressure with your thumbs.
Removal
1. REMOVE FRONT DOOR WINDOW FRAME MOULDING
Remove the screw.
Using a heat light, heat the front door window frame
moulding between 40 to 60 C (104 to 140 F).
NOTICE:
Do not heat the fr ...
Rear door window frame moulding
COMPONENTS
...
Other materials:
Removal
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to
prevent the airbag working.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEE ...
Driver Side Outer Mirror
DTC B1209 Driver Side Outer Mirror
DESCRIPTION
This DTC is detected when communication between the outer mirror control ECU
LH and multiplex
network gateway ECU stops for more than 10 seconds
DTC No.
DTC Detection Condition
Trouble Area
B1209
Driver sid ...
Fuel Pump Control Circuit
DESCRIPTION
The FUEL PUMP relay switches the fuel pump speed according to the engine
conditions. The fuel pump
operates when the ECM receives the starter-operating signal (STA) and
crankshaft-rotating signal (NE).
The FUEL PUMP relay is turned ON while the engine is idling or operating at l ...
