1. INSTALL BACK DOOR OUTSIDE GARNISH
2. INSTALL LH BACK-UP LIGHT ASSEMBLY (See page LI-90)
3. INSTALL RH BACK-UP LIGHT ASSEMBLY (See page LI-90)
4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
5. INSTALL BACK DOOR PULL STRAP (See page ED- 223)
6. INSTALL BACK DOOR LH SIDE GARNISH
7. INSTALL BACK DOOR RH SIDE GARNISH
8. INSTALL POWER BACK DOOR ROD
9. INSTALL BACK DOOR CENTER GARNISH
Vehicle Speed Signal Error (Test Mode DTC)
DTC C2191/91 Vehicle Speed Signal Error (Test Mode DTC)
DESCRIPTION
The tire pressure warning ECU receives a speed signal from the combination
meter. This DTC is stored
upon entering test mode, and cleared when a vehicle speed signal of 12 mph (20
km/h) is detected for 3
seconds or more. Thi ...
Transfer oil
ON-VEHICLE INSPECTION
1. INSPECT TRANSFER OIL
(a) Remove the No. 1 plug and gasket.
(b) Check the oil level is within 0 - 5 mm (0 - 0.20 in.)
below the lowest end of the hole for No. 1 plug.
NOTICE:
When changing oil, recheck the oil level after
driving.
Excessively large or small ...
Operation check
1. DOOR LOCK FAIL-SAFE
When a malfunction in the door control switch
(manual switch, interlocked with key operation) has
been detected, door lock/unlock operation becomes
disabled.
2. CHECK ELECTRICAL DOOR LOCK OPERATION
Check the basic function.
Check that a ...