Toyota Sienna Service Manual: Installation
1. INSTALL ROOF HEADLINING ASSEMBLY
- w/ sliding roof: Install the roof headlining with the 5 clips.
- w/o sliding roof: Install the roof headlining with the 3 clips.
NOTICE: In order to prevent the roof headlining from becoming bent, work must be performed by 2 or more persons when removing/installing it.
2. INSTALL ROOF CONSOLE BOX
- Temporarily install the 2 screws to the retainer.
- Set the console box, as shown in the illustration.
- Slide the console box in the direction indicated by the arrow mark in the illustration so that the screws can meet the keyholes.
- Tighten the 2 screws.
- Tighten the 2 torx screws.
Removal
HINT:
On the LH side, use the same procedures as on the RH side.
1. REMOVE FRONT DOOR SCUFF PLATE RH
Using a screwdriver, disengage the 3 clips and 2
claws, and remove the scuff plate.
...
Sliding roof
...
Other materials:
Monitor result information
If you use a generic scan tool, multiply the test value by
the scaling value listed below.
...
Test mode procedure
1. SPEED SENSOR SIGNAL CHECK (WHEN USING SST CHECK WIRE):
HINT:
If the ignition switch is turned from the ON to the ACC
or LOCK position during Test Mode, the DTCs of the
signal check function will be erased.
(a) Turn the ignition switch off.
(b) Check that the steering wheel is in th ...
Capacity and distribution
Cargo capacity depends on the total weight of the occupants.
(Cargo capacity) = (Total load capacity) - (Total weight of occupants)
Steps for Determining Correct Load Limit
Locate the statement “The combined weight of occupants and
cargo should never exceed XXX kg or XXX lbs.” on your ...
