Toyota Sienna Service Manual: Installation
1. INSTALL SLIDING ROOF HOUSING ASSEMBLY
- Install the housing with the 6 nuts.
- Install the 4 brackets with the 8 bolts.
- Connect the 4 hoses and drive gear connector.
2. ADJUST SLIDING ROOF GLASS SUB-ASSEMBLY
- Check for a difference in levels between the sliding roof (roof glass) and roof panel.
Difference: 0 +- 2.0 mm (0.072 in.)
NOTICE: The clearance should be even all around
3. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY
- Using a torx wrench T25, loosen the screw to adjust the sliding roof panel position. When the adjustment has been done, tighten the screw there.
4. RESET SLIDING ROOF POSITION
5. CHECK FOR WATER LEAKS
- Adjusting the sliding roof, check that there is no
water leak.
If a leak is found, readjust the sliding roof.
6. INSTALL ROOF HEADLINING ASSEMBLY
Removal
1. REMOVE ROOF HEADLINING ASSEMBLY
2. REMOVE SLIDING ROOF SIDE GARNISH LH
Disengage the 3 claws.
Disengage the rear clip.
Disengage the front clip.
Remove the slide garnish by pulling i ...
Sliding roof switch assembly
ON-VEHICLE INSPECTION
1. INSPECT SLIDING ROOF SWITCH ASSEMBLY
Remove the switch.
Check the resistance between the terminals when
operating the switch.
Resistance
If the result is no ...
Other materials:
Installation
1. INSTALL FRONT DOOR GLASS WEATHERSTRIP
Install the front door grass weatherstrip.
2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
(See page MI-45)
3. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY
4. INSTALL POWER WINDOW REGULATOR MASTER
SWITCH ASSEMBLY
5. INSTALL BACK FRAME PLATE
6. INSTALL FR ...
Removal
HINT:
Remove the RH side by same procedures with LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER LINER LH
3. REMOVE FRONT SPEED SENSOR LH
(a) Disconnect the speed sensor connector.
(b) Remove the sensor harness and clamp from the
body.
(c) Remove the 2 clamp bolts holding the ...
Automatic transaxle unit
COMPONENTS
...
