Toyota RAV4 manuals

Toyota Sienna Service Manual: Installation

1. Install vacuum switching valve assembly

Install vacuum switching valve assembly

(a) Install the vacuum switching valve with the screw.

(b) Install the 2 vacuum hoses and vacuum switching valve connector.

Inspection
1. V (a) Inspect VSV operation. (1) Using an ohmmeter, measure the resistance according to the value(s) in the table below.V Standard resistance If the result is not as specified, replace t ...

2Gr-fe exhaust
...

Other materials:

Disassembly
1. REMOVE REAR SEAT LEG COVER LH  Remove the 2 screws and seat leg cover. 2. REMOVE REAR SEAT LEG COVER RH  Remove the 2 screws and seat leg cover. 3. REMOVE REAR SEAT LEG SIDE COVER LH  Remove the 2 screws and leg side cover. 4. REMOVE LH SEAT REAR SEAT LOCK COVE ...

How to proceed with troubleshooting
HINT:  Use the following procedures to troubleshoot the dynamic laser cruise control system.  *: Use the intelligent tester 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS 3 PROBLEM SYMPTOM CONFIRMATION Result SYMPTOM SIMULATION 4 INSPECT BATTERY VOLTAGE Stan ...

Fail-safe chart
1. FAIL-SAFE This function minimizes the loss of the ECT functions when any malfunction occurs in a sensor or solenoid. (a) ATF (Automatic Transmission Fluid) temperature sensor: When the ATF temperature sensor has a malfunction, 5th upshift is prohibited. (b) Counter gear speed sensor NC ...

В© 2011-2025 Copyright www.tsienna.net