1. INSTALL ENGINE OIL COOLER
(a) Clean the oil cooler contact surface on the cooler mounting.
(b) Install a new O-ring to the oil cooler.
(c) Install the oil cooler assembly with the union bolt.
Torque: 68 N*m (693 kgf*cm, 50 ft.*lbf) Install the 2 water by-pass hoses with the bolt, 2 clamps, and 4 clips.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
2. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (See page EM-47) 3. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (See page EM-48) 4. INSTALL NO. 2 MANIFOLD STAY (See page EM-48) 5. INSTALL EXHAUST PIPE ASSEMBLY
for 2WD:(See page EX-4) for 4WD:(See page EX-10)
6. ADD ENGINE OIL (See page LU-6)
7. ADD ENGINE COOLANT (See page CO-7)
8. INSPECT FOR OIL LEAK (See page LU-6)
9. CHECK ENGINE OIL LEVEL
10. INSTALL NO. 1 ENGINE UNDER COVER (See page EM-63)
How to proceed with troubleshooting
Hint:
The ecm of this system is connected to the can and
multiplex communication system. Therefore, before
starting troubleshooting, make sure to check that there is
no trouble in the can and multiplex communication
systems
The intelligent tester can be used at steps 3, 4, 6, and 9.
...
Installation
1. INSTALL SLIDE DOOR ROLLER ASSEMBLY UPPER
Apply MP grease to the rotating area of the roller.
Install the roller with the 2 bolts.
Torque: 13 N*m (130 kgf*cm, 10 ft.*lbf)
2. INSTALL SLIDE DOOR HINGE ASSEMBLY CENTER LH
Apply MP grease to the rotating areas of the hinge.
Ins ...
Passenger Airbag ON/OFF Indicator Circuit
Malfunction
DTC B1152/28 Passenger Airbag ON/OFF Indicator Circuit
Malfunction
DESCRIPTION
The passenger airbag ON/OFF indicator circuit consists of the center airbag
sensor assembly and
passenger airbag ON/OFF indicator.
This circuit indicates the operation condition of the front passenger airbag, ...