1. INSTALL TRANSAXLE HOUSING OIL SEAL
(a) Using SST and a hammer, install a new oil seal.
SST 09316-60011 (09316-00011) Oil seal installation depth: -0.5 to 0.5 mm (-0.020 to 0.020 in.) (b) Coat the lip of the oil seal with MP grease.
2. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
(a) Using SST and a hammer, install a new oil seal.
SST 09223-15020, 09950-70010 (09951-07150) Oil seal installation depth: -0.5 to 0.5 mm (-0.020 to 0.020 in.) (b) Coat the lip of the oil seal with MP grease.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
HINT: (See page DS-17)
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (for 2WD)
HINT: (See page DS-17)
5. INSTALL FRONT WHEELS Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 6. ADD AUTOMATIC TRANSAXLE FLUID 7. INSPECT AUTOMATIC TRANSAXLE FLUID (See page AX-123) 8. INSTALL ENGINE UNDER COVER NO.1 9. CHECK ABS SPEED SENSOR SIGNAL
HINT: (See page BC-82)
Removal
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
HINT:
(See page EM-26)
2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
HINT:
(See page DS-6)
3. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
HINT:
(See page DS-6)
4. REMOVE TRANSMISSION CONTROL CABLE CLAMP
(a) Remove the bolt and the transmission control cable
cla ...
Installation
1. INSTALL WINDSHIELD GLASS NO.2 STOPPER
Coat the installation part of the stoppers with Primer
G.
NOTICE:
Allow the primer coating to dry for 3 minutes
or more.
Do not keep any of the opened Primer G for
later use.
Do not apply too much Primer .
...
For vehicles equipped with vehicle stability control (vsc) system
(a) Notices when using drum tester
Notices when using drum tester.
(1) When using a drum tester, be sure to start the
engine with the ignition switch OFF, and connect
SST to the terminals TS and CG of the DLC3
before the measurement in order to cancel the
VSC operation.
SST 09843-18040
...