1. INSTALL TRANSFER RH BEARING RETAINER OIL SEAL
(a) Using SST, install a new transfer RH bearing retainer oil seal to the transfer case at the position as show in the illustration.
SST 09223-46011
NOTICE: Do not install the oil seal obliquely
(b) Apply small amount of MP grease to the oil seal lip.
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
HINT: (See page DS-17)
3. INSTALL FRONT WHEEL Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
4. ADD AUTOMATIC TRANSAXLE FLUID
5. INSTALL TRANSFER DRAIN PLUG
(a) Install the transfer drain plug with a new drain gasket.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
6. INSTALL NO. 1 TRANSFER CASE PLUG
(a) Add oil up 0 to 5 mm (0 to 0.20 in.) below the lower side of the plug hole.
Oil amount : 0.9 L (0.95 US qts, 0.71 lmp.qts)
HINT: When adding oil, pour it slowly.
(b) Install the No. 1 transfer case plug with a new No. 1 gasket.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
7. CHECK FOR EXHAUST GAS LEAK
8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT: (See page SP-4)
9. CHECK ABS SPEED SENSOR SIGNAL
HINT: (See page BC-3)
Communication Error of Yaw Rate Sensor
DTC U0123 Communication Error of Yaw Rate Sensor
DESCRIPTION
This circuit detects the yaw rate of the vehicle and transmits its signal to
the skid control ECU and
distance control ECU.
DTC No.
DTC Detection Condition
Trouble Area
U0123
While the dynamic ...
Personal light assembly
ON-VEHICLE INSPECTION
1. ROOF CONSOLE BOX ASSEMBLY
Inspect map light assembly resistance.
Check the resistance between the terminals at
each switch position as shown in the chart.
Resistance
...
CD cannot be Inserted / Played or CD is Ejected Right After Insertion
INSPECTION PROCEDURE
1 CHECK IF A PROPER CD IS INSERTED
Make sure that the CD is an audio CD or a CD with an
MP3 or WMA file, and that it is not deformed, flawed,
stained, burred, or otherwise defective.
OK:
Normal CD
HINT:
Translucent or uniquely-shaped CDs cannot be
playe ...