1. INSTALL TRANSFER CASE OIL SEAL
(a) Using SST, install anew transfer case oil seal to the transfer case at the position shown in the illustration.
SST 09387-00010, 09950-70010 (09951-07150)
NOTICE: Do not install it obliquely.
(b) Apply small amount of MP grease to the oil seal lip.
2. INSTALL CTR DIFFERENTIAL LOCK SLEEVE
HINT: (See page TF-22)
3. INSTALL TRANSFER ASSEMBLY
HINT: (See page TF-9)
4. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER
HINT: See page AX-167
5. INSTALL ENGINE AND TRANSAXLE
HINT: (See page EM-44)
6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT: (See page SP-4)
7. CHECK ABS SPEED SENSOR SIGNAL
HINT: (See page BC-3)
Removal
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to
prevent the airbag working.
3. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER L ...
ON / OFF Indication Parameter Error
DTC 01-E2 ON / OFF Indication Parameter Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
01-E2
The signal for ON/OFF control from the master device
has a problem
Radio and navigation assembly
INSPECTION PROCEDURE
HINT:
After the insp ...
Installation
1. INSTALL COOLER CONDENSER CORE
(a) Install the cooler condenser core with the 2 screws.
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
HINT:
If the condenser is replaced with a new one, add
compressor oil to the new condenser.
Capacity:
40 cc (1.4 fl.oz.)
Compressor oil:
ND-OIL 8 or equiva ...