1. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(a) Align the matchmarks on the propeller shaft assembly rear flange and differential companion flange, and connect the shaft with the 4 bolts, washers and nuts.
(b) Remove SST(s) from the extension housing.
(c) Insert the yoke into the extension housing.
NOTICE:
(d) Install the 2 adjusting shims and propeller shaft w/ center bearing, and loosely tighten the 4 bolts.
(e) Tighten the 4 nuts.
Torque: 74 N*m (750 kgf*cm, 54 ft.*lbf)
2. FULLY TIGHTEN PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(a) Remove the cloth from the joint.
(b) Using a hexagon wrench (6 mm), tighten the 6 bolts.
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
(c) With the vehicle unloaded, adjust the dimension between the rear side of the cover and shaft, as shown in the illustration.
(d) Adjust the front and rear dimensions between the edge surface of the center support bearing and the edge surface of the cushion to 12.5 +- 1.0 mm (0.492 +- 0.039 in.) respectively as shown in the illustration, then torque the bolts.
Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf) (e) Check that the center line of the bracket is at right angles to the shaft axial direction.
(f) If any vibration or noise occurs, perform joint angle check as follows and replace the adjusting shim with a proper one.
(1) Turn the propeller shaft several times by hand to stabilize the center support bearings.
(2) Using a jack, raise and lower the differential to stabilize the differential mounting cushion.
(3) Remove the transfer dynamic damper.
(4) Using SST(s), measure the installation angle of the transfer extension housing (A) and front propeller shaft (B).
SST 09370-50010 No. 1 joint angle: A minus B = -0.4° to -1.6°
(5) Using SST(s), measure the installation angle of the rear propeller shaft (C) and rear differential (D).
SST 09370-50010 No. 2 joint angle: C minus D = -1.6° to -3.6°
If the measured angle is not within the specification, adjust with the center support bearing adjusting shim.
Center support bearing adjusting shim thickness
(g) Install the transfer dynamic damper.
Torque: 26 N*m (260 kgf*cm, 19 ft.*lbf)
3. INSTALL EXHAUST PIPE ASSEMBLY
(a) Install exhaust pipe assembly (See page EX-10).
Power Slide Door Warning Buzzer RH does not Sound
DESCRIPTION
The power slide door system uses warning buzzers built into RH
slide doors respectively. Each buzzer
has 2 ways of sounding that are used differently according to the
situations:
When all the following conditions are met, the warning buzzer sounds at
a cycle of ...
Steering Angle Sensor Zero Point Malfunction
DTC C1290/66 Steering Angle Sensor Zero Point Malfunction
DESCRIPTION
The skid control ECU acquires steering angle sensor zero point every time the
ignition switch is turned to
the ON position and the vehicle is driven at 35 km/h (22 mph) or more for
approximately 5 seconds. The
ECU also sto ...
Terminals of ECU
1. CHECK OUTER MIRROR CONTROL ECU LH
Disconnect the O9 and O10 connectors.
Measure the voltage and resistance according to
the value(s) in the table below.
Voltage
Resistance
If the result is not as specified, there may be a
malfunction on the wire harness side.
Recon ...