Toyota RAV4 manuals

Toyota Sienna 2010-2024 Owners Manual: Installing child restraints

Follow the child restraint system manufacturer’s instructions.

Firmly secure child restraints to the rear seats using the LATCH anchors or a seat belt. Attach the top tether strap when installing a child restraint.

The lap/shoulder belt can be used if your child restraint system is not compatible with the LATCH (Lower Anchors and Tethers for Children) system.

Child restraint LATCH anchors

LATCH anchors are provided for second outside seats. (Buttons displaying the location of the anchors are attached to the seats.)

Toyota Sienna. Child restraint LATCH anchors


LATCH anchors are provided for both second seats. (Buttons displaying the location of the anchors are attached to the seats.)

Toyota Sienna. Child restraint LATCH anchors


LATCH anchors are provided for the right outboard seat and center seat. (Buttons displaying the location of the anchors are attached to the seats.)

Toyota Sienna. Child restraint LATCH anchors


Seat belts equipped with a child restraint locking mechanism (ALR/ELR belts except driver’s seat belt)

Toyota Sienna. Child restraint LATCH anchors


Anchor brackets (for top tether strap)

Anchor brackets are provided for second outside seats.

Toyota Sienna. Child restraint LATCH anchors


Anchor brackets are provided for both second seats.

Toyota Sienna. Child restraint LATCH anchors


An anchor brackets are provided for the right outboard seat and center seat.

Toyota Sienna. Child restraint LATCH anchors


Types of child restraints
Child restraint systems are classified into the following 3 types according to the age and size of the child: Rear facing - Infant seat/convertible seat Forward facing - Convertible sea ...

Installation with LATCH system (second seat)
Fold the seatback while pulling the lever and move to the rearmost recline position. Widen the gap between the seat cushion and seatback slightly. Type A Latch the hooks o ...

Other materials:

Vehicle Speed Sensor Malfunction
DTC P0500 Vehicle Speed Sensor Malfunction DTC P0503 Vehicle Speed Sensor Circuit Malfunction DESCRIPTION The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P0500 is detected, perform the diagnosis using the inspection procedure ...

Driving in vehicle-to-vehicle distance control mode
This mode employs a radar sensor to detect the presence of vehicles up to approximately 400 ft. (120 m) ahead, determines the current vehicle-to-vehicle following distance, and operates to maintain a suitable following distance from the vehicle ahead. Note that vehicle-to-vehicle distance will ...

Inspection
1. INSPECT MASS AIR FLOW METER  Visually check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter. OK: There is no foreign matter. If the result is not as specified, replace the mass air flow meter. Measure the resistance according to the ...

© 2011-2024 Copyright www.tsienna.net