Toyota Sienna Service Manual: Integration control and panel

Disassembly

1. REMOVE CONTROL KNOB SUB-ASSEMBLY (for Manual Air Conditioning System) (a) Remove the control knob sub-assembly. 2. REMOVE AIR CONDITIONING CONTROL BULB (a) Remove the air conditioning co ...

Removal

1. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER NO.1 (See page IP-8) 2. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER NO.2 3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY HINT: (See page AX-146 for U15 ...

Other materials:

Battery
Check the battery as follows: Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. Terminals Hold-down clamp Before recharging When recharging, the battery produces hydrogen gas which is flammable an ...

Road test
1. PROBLEM SYMPTOM CONFIRMATION HINT: The dynamic laser cruise control system has two cruise control modes: the constant speed control mode and vehicle-to-vehicle distance control mode.  The vehicle-to-vehicle distance control mode is always selected when starting up the dynamic laser ...

DTC check / clear
1. DTC CHECK  Connect the intelligent tester to the DLC3.  Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the Data Link Connector 3 (DLC3).  Turn the ignition switch to the ON posi ...