Toyota Sienna Service Manual: Low pitched horn
COMPONENTS
REMOVAL
1. REMOVE FRONT BUMPER COVER ET-3
2. REMOVE LOW PITCHED HORN
- Disconnect the connector.
- Remove the bolt and horn.
INSPECTION
1. INSPECT LOW PITCHED HORN
- Apply battery voltage and check operation of the horn, as shown in the table.
Standard
INSTALLATION
1. INSTALL LOW PITCHED HORN
- Place the stay onto the baffle part of the radiator
support upper and then install the horn with the bolt.
Torque: 20 N*m (199 kgf*cm, 15 ft.*lbf)
- Connect the connector.
2. INSTALL FRONT BUMPER COVER
Horn relay
INSPECTION
1. INSPECT HORN RELAY
Remove the horn relay from the instrument panel J/
B.
Measure the horn relay continuity.
Standard
...
High pitched horn
COMPONENTS
REMOVAL
1. REMOVE FRONT BUMPER COVER
2. REMOVE HIGH PITCHED HORN
Disconnect the connector.
Remove the bolt and horn.
INSPECTION
1. INSPECT HIGH PITCHED HORN
...
Other materials:
Trailer Tongue Weight
A recommended tongue weight varies in accordance with the types
of trailers or towing as described below.
To ensure the recommended values shown below, the trailer must
be loaded by referring to the following instructions.
Tongue Weight
The gross trailer weight should be distribute ...
Engine assembly
Components
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE (See page
FU-13)
2. DISCHARGE REFRIGERANT FROM
REFRIGERATION SYSTEM (See page AC-172)
3. REMOVE BATTERY
(a) Disconnect the negative battery terminal.
(b) Disconnect the positive battery ...
Removal
1. REMOVE REAR SEAT LEG SIDE GARNISH SUBASSEMBLY RH
Disengage the clips and remove the seat leg side
garnish sub-assembly RH.
2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH
Remove the bolt and locus cable RH.
Remove the 2 bolts and rear No. 2 seat assembly
RH.
R ...
