Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Maintenance and care

Safety information for Safety Connect
Important! Read this information before using Safety Connect. Exposure to radio frequency signals The Safety Connect system installed in your vehicle is a low-power radio transmitter and receiver. ...

Maintenance and care
...

Other materials:

DRL Relay Circuit
DESCRIPTION The Multiplex network body ECU controls the DRL No.2 relay WIRING DIAGRAM INSPECTION PROCEDURE 1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER Connect the intelligent tester to DLC3.  Turn the ignition switch ON and push the intelligent tester main switch ON.  Sel ...

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are displayed by the blinking pattern of the ABS warning light. WIRING DIAGRAM HINT: When warning lights continue to blink, a ground short in the wiring of terminal TC of the DLC3 or an internal ...

On-vehicle inspection
1. CONNECT INTELLIGENT TESTER (a) Connect the intelligent tester to the DLC3. (b) Start the engine and run at idle. (c) Select the ACTIVE TEST mode on the intelligent tester. HINT: Please refer to the intelligent tester operator's manual for further details. 2. INSPECT ACTUATOR MOTOR ...

В© 2011-2026 Copyright www.tsienna.net