1. Perform manual shifting test
Hint:
(A) disconnect the connector of the transmission wire.
(B) drive with the transmission wire disconnected.
Shifting the shift lever in the order of l, 2, 3, 4 and d position to check whether the shifting condition changes the table below.
Hint:
When driving with the transmission wire disconnected, the shift lever position is in l or 2, the gear position is held in 3rd and the shift lever position is in 3, 4 or d, the gear position is held in 4th. However, when the shift position is in r or p, the operation is same as usual
(C) connect the connector of the transmission wire.
(D) clear the dtc (see page ax-27).
Window lock switch
Press the switch down to lock the
passenger window switches.
Use this switch to prevent children
from accidentally opening or closing
a passenger window.
The power windows can be operated when
The engine switch is in the “ON” position (vehicles without a smart key
system)
or IGNIT ...
On-vehicle inspection
1. INSPECT BRAKE PEDAL HEIGHT
(a) Check the brake pedal height.
Pedal height from dash panel:
150.3 to 160.3 mm (5.917 to 6.311 in.)
NOTICE:
Do not adjust the pedal height. Doing so by
changing the push rod length will structurally
change the pedal ratio.
2. CHECK AND ADJUST STOP LIGHT S ...
Front Clearance Sonar Sensor RH Circuit
DESCRIPTION
An ultrasonic sensor consists of a sensor portion that transmits and receives
ultrasonic waves and a preamplifier
that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and
sends the reveiced
signals to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PR ...