Toyota Sienna Service Manual: Map Disc cannot be Inserted
INSPECTION PROCEDURE
1 CHECK RADIO AND NAVIGATION ASSEMBLY
- Check if a disc is inserted into the MAP disc slot.
- Check if "DISC IN" is displayed.
OK: "DISC IN" is displayed
2 CHECK MAP DISC
- Check that the map disc is not deformed or cracked.
OK: No deformations or cracks on map disc.
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Poor Sound Quality in All Modes (Low Volume)
INSPECTION PROCEDURE
1 CHECK AUDIO SETTINGS
Set "BASS", "MID" and "TREB" to the initial values and
check that sound is normal.
OK:
Malfunction disappears.
2 C ...
Vehicle Position Mark Deviates Greatly
INSPECTION PROCEDURE
1 CHECK GPS MARK
Check that the GPS mark is displayed.
OK:
GPS mark is displayed
2 CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
Enter the "Navigation Ch ...
Other materials:
Message Settings
Display the “Phone/Message Settings” screen.
Select “Messaging Settings”.
Select the desired item to be set.
Set automatic message
transfer on/off.
Set automatic message
readout on/off.
Set the SMS/MMS notification
popup on/off.
Set the e-mail notification
pop ...
Steering Pad Switch Circuit
DESCRIPTION
This circuit sends an operation signal from the steering pad switch to the
radio receiver.
If there is an open in the circuit, the navigation system cannot be operated
using the steering pad switch.
If there is a short in the circuit, the resulting condition is the same as if ...
Drive shaft
SST
RECOMMENDED TOOLS
HINT:
Torx is a registered trademark of Textron Inc.
EQUIPMENT
LUBRICANT
...
