Toyota RAV4 manuals

Toyota Sienna 2010-2024 Owners Manual: Memory recall function

Each electronic key can be registered to recall your preferred driving position.

Registering procedure

Record your driving position to button “1” or “2” before performing the following: Carry only the key you want to register, and then close the driver’s door.

If 2 or more keys are in the vehicle, the driving position cannot be recorded properly.

Toyota Sienna.  Registering procedure


  1. Check that the shift lever is in P.
  2. Turn the engine switch to IGNITION ON mode.
  3. Recall the driving position that you want to record.
  4. While pressing the recalled button, press and hold the door lock switch (either lock or unlock) until the signal beeps.

Recall procedure

Carry the electronic key that has been registered to the driving position, and then unlock and open the driver’s door using the smart key system or wireless remote control.

The driving position will move to the recorded position.

If the driving position is in a position that has already been recorded, the seat and outside rear view mirrors will not move.

Cancelation procedure

Carry only the key you want to cancel and then close the driver’s door.

If 2 or more keys are in the vehicle, the driving position cannot be canceled properly.

  1. Check that the shift lever is in P.
  2. Turn the engine switch to IGNITION ON mode
  3. While pressing the “SET” button, press and hold the door lock switch (either lock or unlock) until the signal beeps twice.

    If the button could not be canceled, the signal beeps continuously for approximately 3 seconds.

Recalling the driving position using the memory recall function

Customization

The unlock door settings of the memory recall function can be customized.

(Customizable features: )

WARNING

Seat adjustment caution

Take care during seat adjustment so that the seat does not strike the rear passenger or squeeze your body against the steering wheel.

Driving position memory
Your preferred driving position (the position of the driver’s seat and outside rear view mirrors) can be recalled by pressing a button. Two different driving positions can be recorded into memor ...

Head restraints
Head restraints are provided for all seats. ...

Other materials:

On-vehicle inspection
1. CONNECT INTELLIGENT TESTER (a) Connect the intelligent tester to the DLC3. (b) Start the engine and run at idle. (c) Select the ACTIVE TEST mode on the intelligent tester. HINT: Please refer to the intelligent tester operator's manual for further details. 2. INSPECT ACTUATOR MOTOR ...

Short to GND in Front Passenger Side Squib Circuit
DTC B0107/51 Short to GND in Front Passenger Side Squib Circuit DESCRIPTION The front passenger side squib circuit consists of the center airbag sensor assembly and the front passenger airbag assembly. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B0107/ ...

Disassembly
1. REMOVE GENERATOR CLUTCH PULLEY (A) using a screwdriver, remove the generator pulley cap. (b) Set SST (A) and (B). SST 09820-63020 (c) Clamp SST (A) in a vise. NOTICE: Be sure to fix the flat surface of SST (A) in a vise. (d) Place the rotor shaft end int ...

© 2011-2024 Copyright www.tsienna.net