DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK MULTIPLEX COMMUNICATION SYSTEM
Result
2 CHECK DTC
Result
3 PERFORM ACTIVE TEST BY INTELLIGENT TESTER
MAIN BODY:
OK: The meter illumination is dimmed when the DIMMER SIG is ON.
CHECK LIGHTING SETTING
4 REPLACE COMBINATION METER ASSEMBLY
OK: The operation of the combination meter assembly returns to normal.
END
Installation
1. INSTALL CENTER REAR SEAT LAP TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for reassembly of the rear No. 1
seat assembly (for center seat).
Install the center rear seat lap type belt assembly
with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. IN ...
Map Disc cannot be Inserted
INSPECTION PROCEDURE
1 CHECK RADIO AND NAVIGATION ASSEMBLY
Check if a disc is inserted into the MAP disc slot.
Check if "DISC IN" is displayed.
OK:
"DISC IN" is displayed
2 CHECK MAP DISC
Check that the map disc is not deformed or cracked.
OK: ...
Power slide door main switch
INSPECTION
1. INSPECT POWER SLIDE DOOR MAIN SWITCH
Inspect the resistance of the switch.
Resistance
If the result is not as specified, replace the switch.
Apply battery voltage and check the illuminates.
Standard
HINT:
Whether the switch illuminates or not will not affect
...