Toyota Sienna Service Manual: Mirror Switch Circuit
DESCRIPTION
- A switch signal of the outer mirror switch is transmitted to the selected outer mirror control ECU by way of the body ECU. Then, the outer mirror control ECU activates the mirror motor to move the mirror UP, DOWN, RIGHT and LEFT in response to the inputs.
HINT: The power mirror control system is part of the multiplex communication system (BEAN). This system features shared communication wiring that reduces the wiring complexity of the communication lines.
The first step in any repair is to confirm the proper operation of the communication system. Proceed with troubleshooting after the communication has been verified (See Multiplex Communication System).
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT OUTER MIRROR SWITCH
- Remove the outer mirror control switch.
- Measure the resistance according to the value(s) in the table below when the switch is operated.
Resistance
*1: The L or R of the left / right adjustment switch.
2 CHECK WIRE HARNESS (OUTER MIRROR SWITCH - MAIN BODY ECU RH)
- Disconnect the B6 ECU connector.
- Measure the resistance according to the value(s) in the table below.
Resistance
PROCEED TO NEXT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Door Mirror Foot Light Circuit
DESCRIPTION
When the outer mirror control ECU receives the signal(s) from the body ECU
through BEAN
communication, it illuminates the foot light. The foot light is installed on the
bottom of the ...
Mirror Motor Circuit
DESCRIPTION
A mirror control switch signal and memorized mirror positions are sent to the
outer mirror control ECU.
The outer mirror control ECU drives the selected mirror UP, DOWN, LEFT and RIG ...
Other materials:
Phone screen
To display the screen shown below, press the
switch on the steering
wheel or the button.
Several functions are available to operate on each screen that is displayed
by selecting the 4 tabs.
Device name
Bluetooth® connection status
Telephone switch
Microphone
The vehicleâ ...
Power slide door touch sensor
INSPECTION
1. INSPECT POWER SLIDE DOOR TOUCH SENSOR LH
Check the resistance of the sensor.
Resistance
If the result is not as specified, replace the sensor.
2. INSPECT POWER SLIDE DOOR TOUCH SENSOR RH
Check the resistance of the sensor.
Resistance
If the result is not a ...
Bluetooth
When using the Bluetooth® audio system
In the following conditions, the system may not function.
If the portable audio player is turned off
If the portable audio player is not connected
If the portable audio player’s battery is low
There may be a delay if a cellular phone conn ...
