Toyota RAV4 manuals

Toyota Sienna Service Manual: Navigation antenna

COMPONENTS

COMPONENTS

COMPONENTS

Installation
1. INSTALL NO.1 NAVIGATION BRACKET  Install the No.1 navigation bracket with the 4 screws. 2. INSTALL NO.2 NAVIGATION BRACKET  Install the No.2 navigation bracket with t ...

Removal
1. BOLT, SCREW AND NUT TABLE  The bolts, the screws and the nuts, which are necessary for installation and removal of the instrument panel are shown in the illustration below with alpha ...

Other materials:

Power back door touch sensor
INSPECTION 1. INSPECT POWER BACK DOOR TOUCH SENSOR LH Check the resistance of the sensor. Resistance If the result is not as specified, replace the sensor. 2. INSPECT POWER BACK DOOR TOUCH SENSOR RH Check the resistance of the sensor. Resistance If the result is not as ...

Open in Stop Light Switch Circuit
DTC C1249/49 Open in Stop Light Switch Circuit DESCRIPTION This skid control ECU inputs the stop light switch signal and detects the status of brake operation. The skid control ECU has an open detection circuit. If an open in the stop light switch input line or GND side stop light circuit ...

Removal
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: Wait for 90 se ...

В© 2011-2026 Copyright www.tsienna.net