COMPONENTS
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE LH
2. REMOVE COWL SIDE TRIM BOARD LH
3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER LH (See page IP-6)
4. REMOVE INSTRUMENT PANEL SAFETY PAD INSERT NO. 1 (See page IP-6)
5. REMOVE CLEARANCE WARNING ECU ASSEMBLY (See page PM-15)
6. REMOVE NETWORK GATEWAY ECU
INSTALLATION
1. INSTALL NETWORK GATEWAY ECU
2. INSTALL CLEARANCE WARNING ECU ASSEMBLY (See page PM-15)
3. INSTALL PANEL SAFETY PAD INSERT NO. 1
4. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER LH
5. REMOVE COWL SIDE TRIM BOARD LH
6. REMOVE FRONT DOOR SCUFF PLATE LH
Door control switch
INSPECTION
1. INSPECT DOOR CONTROL SWITCH ASSEMBLY
Measure the resistance according to the value(s) in
the table below.
Standard resistance
HINT:
If the result is not as specified, replace the switch. ...
Brake Warning Light Remains ON
DESCRIPTION
The BRAKE warning light comes on when the brake fluid is insufficient, the
parking brake is applied or the
EBD is defective.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When releasing the parking brake, move the shift lever into the P position in an
AT vehicle, and choke in
...
Shift Solenoid "E" Performance (Shift Solenoid
Valve SR)
SYSTEM DESCRIPTION
The ECM uses signals from the vehicle speed sensor to detect the actual gear
position (1st, 2nd, 3rd, 4th
or 5th gear).
Then the ECM compares the actual gear with the shift schedule in the ECM memory
to detect mechanical
problems of the shift solenoid valves, valve b ...