DESCRIPTION
The clearance warning ECU receives the ultrasonic sensor signal to sound the front warning buzzer.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FRONT BUZZER
HINT: The clearance warning buzzer is separately excited, and will not sound unless an alternating voltage is applied.
OK: Operating noise (clicking sounds) can be heard.
2 CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - FRONT BUZZER)
Standard resistance
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Remote Up / Down Function does not Operate
DESCRIPTION
If the REMOTE UP/DOWN function does not operate, any of the following
troubles may be the cause:
There is an open or short circuit in the wiring between the power
window master switch and the
applicable power window regulator switch.
The power window master swit ...
Data list / active test
1. READ DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows switch,
actuator and other item values to be read without
removing any parts. Reading the DATA LIST early in
troubleshooting is one way to save time.
Connect the intelligent tester with CAN VIM to the
DLC3.
&n ...
Adjusting the set speed
To change the set speed, operate the lever until the desired set speed
is obtained.
Increases the speed
Decreases the speed
Fine adjustment: Momentarily
move the lever in the desired direction.
Large adjustment: Hold the lever in
the desired direction.
The set speed will be incre ...