Toyota Sienna Service Manual: Occupant classification system
- Precaution
- System description
- How to proceed with troubleshooting
- Initialization
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Data list / active test
- Diagnostic trouble code chart
Diagnosis Circuit
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking the SRS warning light.
HINT:
When each warning light stays blinking, a g ...
Precaution
1. INSPECTION PROCEDURE FOR VEHICLE INVOLVED
IN ACCIDENT
Perform the zero point calibration and sensitivity
check if any of the following conditions occur.
The occupant classi ...
Other materials:
Installation
1. INSTALL STABILIZER BAR FRONT
2. INSTALL FRONT STABILIZER BAR BUSH NO.1
(a) Install the front stabilizer bar bush No. 1.
HINT:
Install the bushing to the outer side of the bushing
stopper on the stabilizer bar as shown in the
illustration.
4. INSTALL RACK & PINION POWER STEERING GEA ...
Disassembly
1. REMOVE GENERATOR CLUTCH PULLEY
(A) using a screwdriver, remove the generator pulley
cap.
(b) Set SST (A) and (B).
SST 09820-63020
(c) Clamp SST (A) in a vise.
NOTICE:
Be sure to fix the flat surface of SST (A) in a
vise.
(d) Place the rotor shaft end int ...
Calling the message sender
Calls can be made to an e-mail/SMS/MMS message sender’s phone
number.
Display the message inbox screen.
Select the desired message.
Select .
Check that the “Call” screen is displayed.
Calling from a number within a message
Calls can be made to a number identified in a message ...
