Toyota Sienna Service Manual: ON / OFF Indication Parameter Error
DTC 01-E2 ON / OFF Indication Parameter Error
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
| 01-E2 | The signal for ON/OFF control from the master device has a problem | Radio and navigation assembly |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 REPLACE RADIO AND NAVIGATION ASSEMBLY
END
Registration Complete Indication Error/ Registration Demand Transmission/
Multiple Frame Incomplete
DTC 01-E0 Registration Complete Indication Error
DTC 01-E3 Registration Demand Transmission
DTC 01-E4 Multiple Frame Incomplete
DESCRIPTION
DTC No.
DTC Detection Condition
...
Panel Switch Error/ Touch Switch Error
DTC 21-10 Panel Switch Error
DTC 21-11 Touch Switch Error
DTC 23-10 Panel Switch Error
DTC 23-11 Touch Switch Error
DTC 24-10 Panel Switch Error
DTC 24-11 To ...
Other materials:
Inspection
1. INSPECT BRAKE DISC INSIDE DIAMETER
(a) Using a brake drum gauge or equivalent, measure
the inside diameter of the disc.
Standard inside diameter:
190 mm (7.480 in.)
Maximum inside diameter:
191 mm (7.520 in.)
2. INSPECT PARKING BRAKE SHOE LINING THICKNESS
(a) Using a ruler, measur ...
Short to GND in Front Passenger Side Squib
Circuit
DTC B0107/51 Short to GND in Front Passenger Side Squib
Circuit
DESCRIPTION
The front passenger side squib circuit consists of the center airbag sensor
assembly and the front
passenger airbag assembly.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0107/ ...
Dtc check / clear
1. DTC CHECK (NORMAL MODE)
NOTICE:
When the diagnostic system is switched from the
normal mode to the check mode, all the DTCs and
freeze frame data recorded in the normal mode will
be erased. So before switching modes, always check
the DTCs and freeze frame data, and note the ...
