Toyota Sienna Service Manual: On-vehicle inspection
1. INSPECT REAR AXLE HUB BEARING BACKLASH
(a) Using a dial gauge, check for backlash near the center of the axle hub.
Maximum: 0.05 mm (0.0020 in.)
If backlash exceeds the maximum, replace the axle hub assembly.
NOTICE: Ensure that the dial gauge is set at right angles to the measurement surface.
2. INSPECT REAR AXLE HUB BEARING DEVIATION
(a) Using a dial gauge, check for deviation in the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0027 in.)
If backlash exceeds the maximum, replace the axle hub assembly.
NOTICE: Ensure that the dial gauge is set at right angles to the measurement surface.
Rear axle hub and bearing (for 2wd)
COMPONENTS
...
Removal
HINT:
Replace the RH side by the same procedures as the LH side.
1. REMOVE REAR WHEEL
2. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY
LH
(a) Removing the 2 bolts, separate the rear disc brake
caliper ...
Other materials:
Back Sonar Sensor RH Circuit
DESCRIPTION
An ultrasonic sensor consists of a sensor portion that transmits and receives
ultrasonic waves and a preamplifier
that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and
sends the received
signals to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PR ...
Dtc check / clear
1. DTC CHECK (USING SST CHECK WIRE)
(a) Check DTCs.
(1) Turn the ignition switch off.
(2) Using SST, connect terminals TC and CG of
DLC3.
SST 09843-18040
(3) Turn the ignition switch to the ON position.
(4) Read and record any DTCs from the tire
pressure warning light on the combin ...
Reassembly
1. INSTALL FRONT DOOR WIRE LH
Install the wire with the 2 bolts.
Torque: Reference
8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTICE:
In order to prevent water leakage, be sure that
the lip of the rubber grommet does not turn up
or is not deformed when installing the wire.
Connect the wir ...
