Toyota Sienna Service Manual: On-vehicle inspection

Toyota Sienna Service Manual / Supplemental restraint system / Front seat side airbag assembly / On-vehicle inspection

1. FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

Perform a diagnostic system check.
With the front seat side airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seatback assembly with a new one: Cuts, minute cracks or marked discoloration on the front seatback assembly around the front seat side airbag assembly

2. FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

Perform a diagnostic system check.
With the front seat side airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat side airbag assembly with a new one:

Cuts, minute cracks or marked discoloration on the front seat side airbag assembly.
Cracks or other damage to the wire harness or connector.

CAUTION: Be sure to follow the correct removal and installation procedures.

Front seat side airbag assembly

...

Disposal

HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. When scrapping a vehicle equipped with the SRS or disposing of t ...

Other materials:

Throttle / Pedal Position Sensor / Switch "A/B" Circuit
DTC P0120 Throttle / Pedal Position Sensor / Switch "A" Circuit DTC P0122 Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input DTC P0123 Throttle / Pedal Position Sensor / Switch "A" Circuit High Input DTC P0220 Throttle / Pedal Position Sensor / Switch ...

Check that initialization has been completed
(a) Confirm that the data of tire pressure of all tires are displayed on the intelligent tester screen. Tester Display Measurement Item/Range Normal Condition Diagnostic Note TIREPRESS1 ID1 tire inflation pressure (Absolute pressure) / min.: 100 kPa (1 kgf/cm2, 14 ...

On-vehicle inspection
1. CONNECT INTELLIGENT TESTER (a) Connect the intelligent tester to the DLC3. (b) Start the engine and run at idle. (c) Select the ACTIVE TEST mode on the intelligent tester. HINT: Please refer to the intelligent tester operator's manual for further details. 2. INSPECT ACTUATOR MOTOR ...