Toyota RAV4 manuals

Toyota Sienna Service Manual: On-vehicle inspection

1. INSPECT OCCUPANT CLASSIFICATION ECU (VEHICLE NOT INVOLVED IN COLLISION)

  1.  Perform a diagnostic system check.

2. INSPECT OCCUPANT CLASSIFICATION ECU (VEHICLE INVOLVED IN COLLISION)

  1. Perform a diagnostic system check.
  2.  Even if the airbag was not deployed, check if there is any damage to the occupant classification ECU. If there are any defects as mentioned below, replace the occupant classification ECU with a new one:

CAUTION: Be sure to follow the correct removal and installation procedures.

Occupant classification ECU
COMPONENTS ...

Removal
1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the ...

Other materials:

VSC Warning Light Remains ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN and multiplex communications. If the skid control ECU stores DTCs to shut down TRAC and VSC operation, the VSC warning light comes on in the combination meter. WIRING DIAGRAM INSPECTION PROCEDURE NOTICE: ...

2Gr-fe emission control
SST RECOMMENDED TOOLS EQUIPMENT SSM 2GR-FE INTAKE EQUIPMENT PREPARATION 2GR-FE EXHAUST EQUIPMENT ...

Communication Error from Distance Control ECU to ECM
DTC P1615 Communication Error from Distance Control ECU to ECM DTC U1101 Lost Communication with Distance Control ECU DESCRIPTION The distance control ECU receives information about the area in front of the vehicle from the laser sensor and then sends a brake control demand signal (decelerat ...

В© 2011-2024 Copyright www.tsienna.net